DYNO TESTING

KDR Performance is proud to announce the installation of a Dynojet 248 in-ground dyno. We also have added Dynojet's Lambda Sensor so the customers can actually see the tuning as well as horsepower and torque readings. KDR has the capability to tune the following management systems with in-house software:

  • Apexi AFC
  • Apexi PFC with Datalogic
  • AEM
  • Haltech E6K
  • Haltech E11
  • EFI Systems
  • Electromotive
  • Motec
  • Microtech
 

Dyno cost are charged per hour. For dyno horsepower runs the charge is $75.00 per hour. For dyno-tuning with lambda the cost is $150 per hour.

Also coming for 2004 will be a net-camera so customers can see their car being dyno tested wherever they have Internet access. KDR will also have our project RX7"s progress shown on the Internet each time it is put on the dynometer.

DYNO RELEASE FORM

Performing dyno horsepower or tuning is very stressful on every part of your vehicle, just as drag and/or circuit racing.

There are many problems that can occur beyond our control, regardless of any precautions taken by us, including but not limited to carbon build up on rotors, excessively worn or tired engine, spark plug failure, fuel system dirty or clogged just to name a few.

KDR Performance Inc. Will take every precaution during a dyno session, but it is at the OWNERS SOLE RESPONSIBILITY AND RISK!!

THERE ARE NO GUARANTEES OR WARRANTIES IMPLIED FOR ANY MECHANICAL FAILURE ( clutch, transmission, engine) WHILE PERFORMING DYNO SESSIONS.

By accepting this agreement you accept full responsibility and risks mentioned herein and understand fully that KDR Performance Inc. cannot and will not be held financially responsible for any failure.

Dyno Pricing ( includes strap down and set up)

$ 75.00
$ 175.00
$150.00 Per Hour
$200.00 Per Hour
Dyno Horsepower Runs Only ( 3 runs)
Dyno Tuning w/lambda sensor 10 - 15lbs per session ( up to 2 hours)
Each additional hour (after first 2 hours)
Dyno Tuning w/lambda sensor for over 15lbs using race gas


*Any repairs performed while on the dyno to complete the session will be charged at our current shop rate of $90.00 per hour.

Please Check a box below, by accepting you agree to the terms set forth. By declining to the terms we will not be able to dyno your vehicle or accepts appointments. SORRY.

          I have read, understand and accept the terms set forth in this agreement

          I decline the terms of this agreement and understand you cannot dyno my vehicle

 


Click here to Email Us!
Home | Engines | Transmissions | Dyno | FAQ/General Warranty | Microtech | Performance Parts | V-8 Conversions
Ebay Store | Contact Us

© 2007 KDR Performance, Inc.
Site Designed and Hosted By Enter.Net>